BREIER FIBER UWH FINS WITH BREIER FOOT POCKET
40% more responsive than plastic
Blade: E-glass, Epoxy
Foot Pocket: BREIER Taylor made.
Attention : dernières pièces disponibles !
Date de disponibilité: 0000-00-00
|6||11,27 €||Jusqu'à 67,61 €|
|10||18,09 €||Jusqu'à 180,93 €|
BREIER Underwater hockey fins :
BLADE : FIBER
Technology : prepreg
Fabric : E-glass
Resin : epoxy
Performance : 40% more responsive than plastic
Height : 500 mm
Width : 240 mm
500B1EG : soft
500B2EG : medium
500B3EG : hard
500B4EG : very hard
Abrasion resistant layers of elastomer on both sides of the blade.
T profiles on the edges.
FOOT POCKET : BREIER (Option 0)
Made-to-measure : size from 35 to 50 (3 to 15) neoprene foam pad inside the foot pocket for comfort and protection. They can be used barefoot. Please consult the measurement document available here (in English) (this document is also available in French here) or follow instructions hereafter:
Step 1 : If you usually wear neoprene booties to play, remember to put them on before starting with the foot measurements.
Step 2 : Place a plain piece of paper on the ground flush with a wall (no skirting boards).
Step 3 : Then place your foot flat on the piece of paper with your heel against the wall.
Step 4 : Trace the shape of your foot, holding the pen upright (at 90N to the paper). Repeat for the other foot.
Step 5 : Draw a line across the top of the feet (A - across the big toes), as indicated in Figure 1: The length of the feet.
Step 6 : Measure the distance between this line (A) and the bottom of the page (B) at the heel of the foot (Figure 1).
Step 7 : Record these measurements (A-B) in the boxes below: Lenght - LEFT RIGHT
Step 8 : Keeping your neoprene booties on and your foot flat on the floor, now take a measuring tape to determine the following measurements.
Step 9 : Measure the circumference of the foot from the highest part on top of the foot (Figure 2 : C â€“ the instep) around the hollowed out/indented part of the foot (Figure 2 : D). Repeat for the other foot.
Step 10 : Record these measurements (C â€“ D) in the boxes below: Circumference - LEFT RIGHT
* champs requis